C
HAPTER
25
| SNMP Commands
– 638 –
DEFAULT SETTING
Default groups: public
8
(read only), private
9
(read/write)
readview - Every object belonging to the Internet OID space (1).
writeview - Nothing is defined.
notifyview - Nothing is defined.
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ A group sets the access policy for the assigned users.
◆ When authentication is selected, the MD5 or SHA algorithm is used as
specified in the snmp-server user command.
◆ When privacy is selected, the DES 56-bit algorithm is used for data
encryption.
◆ For additional information on the notification messages supported by
this switch, see Table 22, "Supported Notification Messages," on
page 363. Also, note that the authentication, link-up and link-down
messages are legacy traps and must therefore be enabled in
conjunction with the snmp-server enable traps command.
EXAMPLE
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
8. No view is defined.
9. Maps to the defaultview.
To Next Page
Loading...
