4 - 184
Chapter 4 Disassembly / Assembly and Adjustments
[Replacement]
2) Attach the SHAFT ASSY PIVOT (PL6.1.6), GEAR T4 (PL6.1.5), PIVOT TRANS L (PL6.1.4)
and STOPPER PIVOT (PL6.1.3). (REP6.2)
3) Close the TRANSFER ASSY.
When carrying out the work described next procedure, take care not to scratch
the belt surface of the TRANSFER ASSY.
1) Attach the TRANSFER ASSY to the
printer.
4) Route the harness of the printer
through the hooks of the TRANS-
FER ASSY.
To Next Page
Loading...
