4 - 279
Chapter 4 Disassembly / Assembly and Adjustments
[Replacement]
When carrying out the work described next procedure, take care not to damage
the harnesses of the ADF ASSY and IIT ASSY SUB by pinching them between the
frame and the IIT ASSY SUB.
1) Route the HARN ASSY ADF
through the hole of the IIT ASSY
SUB.
2) Put the IIT ASSY SUB on the
frame, shift it to right side to mate
the four holes of the IIT ASSY SUB
with the studs of the frame.
When carrying out the work
this procedure, route the
harness of the ADF ASSY
and the flat cable into the
printer, route the harness
of the IIT ASSY SUB to
outside.
To Next Page
Loading...
