2 - 27
Chapter 2 Troubleshooting
071 100
Jam at Tray 1
Check Tray 1.
Open/Close Front
Cover.
<IOT Tray1 Misfeed JAM>
The Regi Sensor is not turned ON within the specified
time after feeding a paper from Tray 1.
FIP-1.64
072
This code is given when the Optional 250 Sheet Feeder is installed.
100
Jam at Tray 2
Check Tray 2
Open/Close Front
Cover.
<IOT Tray2 Misfeed JAM>
The Paper Path Sensor of Tray 2 is not turned ON within
the specified time after feeding a paper from Tray 2.
FIP-1.65
101
Jam at Tray 2
Open Tray 2
Open/Close Front
Cover.
<IOT Feeder 2 JAM>
A jam has been detected between the Regi Sensor and
the Paper Sensor of Tray 2.
FIP-1.66
This code is given when the Optional 250-Sheet Feeder is installed.
215
250 Feeder Error
Error 072-215
Restart Printer
<IOT Feeder Configuration Failure>
Option Sheet Feeder Configuration error is detected.
FIP-1.67
216
Motor Error
Error 072-216
Restart Printer
<Option Feeder Motor Failure>
Option Feeder Motor failure is detected.
FIP-1.68
900
Jam at Tray 1 or 2
Open Tray 1 or 2
Open Front Cover
<IOT Remain Option Feeder JAM>
The paper remains at the Paper Path Sensor of Tray 2.
FIP-1.69
075
101
Jam at Front Cover
Open Front Cover
and Remove Paper
<IOT SSF Insert JAM>
SSF No Paper Sensor detect when a paper is inserted
from SSF.
FIP-1.70
102
Jam at Manual Feed
Slot
Remove Paper from
Manual Feed Slot.
Open/Close Front
Cover.
<IOT SSF Paper Pullout JAM>
Though it tried to feed a paper from SSF, the paper was
not loaded or it was pulled out forcibly from SSF.
FIP-1.70
923
Reseat Paper in
the Manual Feed Slot
<Waiting for reseat paper of SSF>
Wait for the paper on SSF to be reseated.
FIP-1.70
077
100
Jam at Front Cover
Open Front Cover
and Remove Paper
<IOT Regi On early JAM>
The paper remains at the paper transfer path between the
Tray 1 and the Regi Sensor.
FIP-1.71
101
Jam at Front Cover
Open Front Cover
and Remove Paper
<IOT Regi OFF Jam>
The paper does not pass through the Regi Sensor within
the specified time.
FIP-1.72
102
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit On JAM>
The paper does not reach the Exit Sensor within the
specified time.
FIP-1.73
103
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit On early JAM>
The paper remains at the paper transfer path between the
Exit Sensor and the Regi Sensor
FIP-1.73
104
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit Off JAM>
The paper does not pass through the Exit Sensor within
the specified time.
FIP-1.74
105
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit Off early JAM>
The paper passed through the Exit Sensor earlier than
the specified time.
FIP-1.74
Status
Code
Error Message
Status Contents
FIP to be
referred
LCD
To Next Page
Loading...
