2 - 28
Chapter 2 Troubleshooting
077
106
Jam at Front Cover
Open Front Cover
and Remove Paper
<IOT Stop Reservation JAM>
Detect jam when stopped before Fusing Unit in forced
stop mode.
FIP-1.73
107
Jam at Duplexer
Open Front Cover
Lift Duplexer
and Remove Paper
<IOT Duplex Misfeed JAM>
In the duplex printing mode, the lead edge does not reach
the Regi Sensor when the sheet changes the direction in
the Duplexer after the standby.
FIP-1.75
108
Jam at Duplexer
Open Front Cover
Lift Duplexer
and Remove Paper
<IOT Duplex JAM>
In the duplex printing mode, the lead edge does not reach
the SSF No Paper Sensor when the sheet changes the
direction in the Duplexer after the standby.
FIP-1.75
215
Duplexer Error
Error 077-215
Restart Printer
<IOT Duplexer Failure>
The error is detected by Duplexer communication check.
FIP-1.76
300
Front Cover Open.
Close Front Cover.
<IOT Cover Front Open>
The Front Cover is open.
FIP-1.77
301
Side Door Open.
Close Side Door.
<IOT Side Cover Open>
The Toner Access Cover is open.
FIP-1.78
900
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit JAM>
The paper remains at the Exit Sensor.
FIP-1.79
901
Jam at Front Cover
Open Front Cover
and Remove Paper
<IOT Remain Registration JAM>
The paper remains at the Regi Sensor.
FIP-1.80
907
Jam at Duplexer
Open Front Cover
Lift Duplexer
and Remove Paper
<IOT Remain Duplex JAM>
The paper remains at the Duplex area.
FIP-1.81
091
402
Ready to Print
Replace Imaging Unit
Soon.
Life Almost Over.
<IOT PHD Life Pre Warning>
The PHD Unit is approaching the replacement time.
FIP-1.82
912
Imaging Unit Error
Remove Imaging
Unit and
Confirm all Yellow
Ribons
are Removed
<PHD Tape Staying>
Detect the tape staying on the PHD Unit.
FIP-1.83
916
CRUM Error
Imaging Unit
Error 091-916
Restart Printer
<IOT PHD CRUM ID Error>
An unsupported PHD Unit is detected.
FIP-1.84
935
Replace
Imaging Unit
<IOT PHD Life Over>
The PHD Unit has reached the replacement time.
FIP-1.85
941
Waste Full
Yellow Cartridge
<IOT CRU Waste (Y) Full>
Waste Toner (Y) Counter value has reached replacement
time.
FIP-1.86
942
Waste Full
Magenta Cartridge
<IOT CRU Waste (M) Full>
Waste Toner (M) Counter value has reached replacement
time.
FIP-1.86
943
Waste Full
Cyan Cartridge
<IOT CRU Waste (C) Full>
Waste Toner (C) Counter value has reached replacement
time.
FIP-1.86
Status
Code
Er
ror Message
St
atus Contents
FIP to be
referred
LCD
To Next Page
Loading...
