6 – 82
Chapter 6 General
FB Motor
1) Turn on the power and enter the FAX Scanner Diag.
2) Open the Platen Cover.
3) Execute "FB Motor".
4) Press "" or "" to select "Forward".
5) Press “OK” key to execute.
6) Check the Carriage going forward.
7) Press "STOP" key to return one step higher menu.
8) Execute "FB Motor" again.
9) Press "" or "" to select "Reverse".
10) Press “OK” key to execute.
11) Check the Carriage going reverse.
12) Press "STOP" key to stop the test.
13) Close the Platen Cover.
NOTE: The motor stops automatically at the end of platen.
ADF Motor
1) Turn on the power and enter the FAX Scanner Diag.
2) Execute "ADF Motor".
3) Press "" or "" to select "Forward".
4) Press “OK” key to execute.
5) Check the ADF Motor driving.
6) Press "STOP" key to stop the test.
NOTE: ADF Cover must be closed when "ADF Motor"executing.
Sensor name Confirmation Procedures
Mnt02056GA
Reverse Forward
Carriage Assy
To Next Page
Loading...
