6 – 81
Chapter 6 General
Lamp
1) Turn on the power and enter the FAX Scanner Diag.
2) Open the Platen Cover.
3) Execute "Lamp".
4) Press "" or "" to select "Set OFF" (Lamp OFF).
5) Press “OK” key to execute.
6) Check the lamp is off.
7) Press "STOP" key to return one step higher menu.
8) Execute "Lamp" again.
9) Press "" or "" to select "Set ON" (Lamp ON).
10) Press “OK” key to execute.
11) Check the lamp is on.
12) Press "STOP" key to stop the test.
13) Close the Platen Cover.
Sensor name Confirmation Procedures
To Next Page
Loading...
