6 – 114
Chapter 6 General
(3) Print Info
Prints out the detailed printer settings and configuration information.
- Executing Print Info
1) Turn off the power.
2) Turn on the power while holding down "" and "" keys.
3) Release the fingers from these keys when "the message" is displayed.
4) The "Customer Mode", "Printer" and "FAX Scanner" are displayed. (Entered the Diag. mode.)
5) Press "OK" key. (Entered the Printer Diag. mode.)
6) Press "" to select "Print Info", and then press "OK" key.
7) Press "" and "" key to select the item.
8) Press "OK" key twice to execute the setting.
To exit the print or to returning to one step higher menu, press "STOP" key.
- Info Page
The version of software of IOT and the printer configuration can be confirmed by executing this
test.
- Print Settings
The service tag, printing count value and error count value can be confirmed by executing this test.
(4) Installation Set
Specifies whether or not Alarm display of Toner residual quantity is performed.
- Executing Installation
1) Turn off the power.
2) Turn on the power while holding down "" and "" keys.
3) Release the fingers from these keys when "the message" is displayed.
4) The "Customer Mode", "Printer" and "FAX Scanner" are displayed. (Entered the Diag. mode.)
5) Press "OK" key. (Entered the Printer Diag. mode.)
6) Press "" to select "Installation", and then press "OK" key.
7) Press "" key to select the ON or OFF.
8) Press "OK" key to execute the setting.
To exit the test or to returning to one step higher menu, press "STOP" key.
To Next Page
Loading...
Need help?
General
