H3C S3100 8C SI - Page 31

Operation Manual – CLI
H3C S3100 Series Ethernet Switches Chapter 1 CLI Configuration
1-11
View
Available
operation
Prompt
example
Enter method Quit method
PoE
profile
view
Configure
PoE profile
parameters
Supported by
only
S3100-TP-P
WR-EI series
switches
[Sysname-poe
-profile-a123]
Execute the
poe-profile command
in system view.
Smart
link
group
view
Configure
smart link
group
parameters
Supported by
only
S3100-EI
series
switches
[Sysname-sml
k-group1]
Execute the
smart-link group
command in system
view.
Monitor
link
group
view
Configure
monitor link
group
parameters
Supported by
only
S3100-EI
series
switches
[Sysname-mtl
k-group1]
Execute the
monitor-link group
command in system
view.
QinQ
view
Configure
QinQ
parameters
Supported by
only
S3100-EI
series
switches
[Sysname-Eth
ernet1/0/1-vid-
20]
Execute the vlan-vpn
vid command in
Ethernet port view.
The vlan-vpn enable
command should be
first executed.
Execute the
quit
command to
return to
Ethernet port
view.
Execute the
return
command to
return to user
view.
 Note:
The shortcut key <Ctrl+Z> is equivalent to the return command.