Operation Manual – Login
H3C S3100 Series Ethernet Switches Chapter 2 Logging in through the Console Port
2-3
Figure 2-4 Set port parameters
3) Turn on the switch. You will be prompted to press the Enter key if the switch
successfully completes POST (power-on self test). The prompt (such as <H3C>)
appears after you press the Enter key, as shown in
Figure 2-5.
Figure 2-5 HyperTerminal CLI
4) You can then configure the switch or check the information about the switch by
executing the corresponding commands. You can also acquire help by typing the ?
character. Refer to related parts in this manual for information about the
commands used for configuring the switch.
To Next Page
Loading...
