H3C S3100 8C SI - Page 598

Operation Manual – Stack-Cluster
H3C S3100 Series Ethernet Switches Chapter 2 Cluste
r
2-13
Operation Command Description
Configure the interval to
collect topology
information periodically
ntdp timer
interval-in-minutes
Optional
By default, the topology
collection interval is one
minute.
Quit system view
quit
—
Launch topology
information collection
manually
ntdp explore
Optional
VI. Enabling the cluster function
Follow these steps to enable the cluster function:
Operation Command Description
Enter system view
system-view
—
Enable the cluster
function globally
cluster enable
Required
By default, the cluster
function is enabled.
VII. Configuring cluster parameters
The establishment of a cluster and the related configuration can be accomplished in
manual mode or automatic mode, as described below.
1) Establishing a cluster and configuring cluster parameters in manual mode
Follow these steps to establish a cluster and configure cluster parameters in manual
mode:
Operation Command Description
Enter system view
system-view
—
Specify the management
VLAN
management-vlan
vlan-id
Required
By default, VLAN 1 is
used as the management
VLAN.
Enter cluster view
cluster
—
Configure a IP address
pool for the cluster
ip-pool
administrator-ip-address
{ ip-mask |
ip-mask-length }
Required
Build a cluster
build name
Required
name: cluster name.