H3C S3100 8C SI User Manual

Operation Manual – Login
H3C S3100 Series Ethernet Switches Chapter 3 Logging in through Telnet
3-11
Operation Command Description
Set the timeout time for
the user interface
idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a
user interface is 10 minutes.
With the timeout time being
10 minutes, the connection to
a user interface is terminated
if no operation is performed in
the user interface within 10
minutes.
You can use the idle-timeout
0 command to disable the
timeout function.
Note that if you configure to authenticate the users in the scheme mode, the command
level available to the users logging into the switch depends on the user privilege level
level command and the service-type { ftp | lan-access | { ssh | telnet | terminal }*
[ level level ] } command, as listed in
Table 3-7.
Table 3-7 Determine the command level when users logging into switches are
authenticated in the scheme mode
Scenario
Authenticati
on mode
User type Command
Command
level
The user privilege level level
command is not executed, and
the service-type command does
not specify the available
command level.
Level 0
The user privilege level level
command is not executed, and
the service-type command
specifies the available command
level.
Determined
by the
service-type
command
The user privilege level level
command is executed, and the
service-type command does not
specify the available command
level.
Level 0
authenticatio
n-mode
scheme
[ command-a
uthorization ]
VTY users that
are
AAA&RADIUS
authenticated
or locally
authenticated
The user privilege level level
command is executed, and the
service-type command specifies
the available command level.
Determined
by the
service-type
command

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English