Operation Manual – Login
H3C S3100 Series Ethernet Switches Chapter 4 Logging in Using a Modem
4-4
Figure 4-3 Set the telephone number
Figure 4-4 Call the modem
5) If the password authentication mode is specified, enter the password when
prompted. If the password is correct, the prompt (such as <Sysname>) appears.
You can then configure or manage the switch. You can also enter the character ?
at anytime for help. Refer to the related parts in this manual for information about
the configuration commands.
 Note:
If you perform no AUX user-related configuration on the switch, the commands of level
3 are available to modem users. Refer to the CLI part for information about command
level.
To Next Page
Loading...
Need help?
General