H3C S3100 8C SI - Page 857

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-11
Operation Command Description
Configure dns-server
dns-server ip-address
z Required: When you use
H3C S3100-EI Series
Switches as HWPing
Client for http test and
set the destination
address as host name.
z This command can not
be supported when you
use H3C S3100-SI
Series Switches as
HWPing Client for http
test.
By default, no IP address of
the DNS server is
configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP
address is configured.
Configure the source port
source-port
port-number
Optional
By default, no source port is
configured.
Configure the number of
probes per test
count times
Optional
By default, each test makes
one probe.
Configure the maximum
number of history records
that can be saved
history-records
number
Optional
By default, the maximum
number is 50.
Configure the automatic
test interval
frequency interval
Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test
will be made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out
in three seconds.
Configure the type of
service
tos value
Optional
By default, the service type
is zero.
Configure the type of
HTTP operation
http-operation { get |
post }
Optional
By default, the type of HTTP
operation is get, that is, the
HTTP operation will get data
from the HTTP server.