Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-12
Operation Command Description
Configure the HTTP
operation string and
version in an HTTP test
http-string string
version
Required
By default, HTTP operation
string and version are not
configured.
Start the test
test-enable
Required
Display test results
display hwping
results [ admin-name
operation-tag ]
Required
You can execute the
command in any view.
5) Configuring jitter test on HWPing client
Table 1-9 Configure jitter test on HWPing client
Operation Command Description
Enter system view
system-view
—
Enable the HWPing client
function
hwping-agent enable
Required
By default, the HWPing
client function is disabled.
Create a HWPing test
group and enter its view
hwping
administrator-name
operation-tag
Required
By default, no test group
is configured.
Configure the test type
test-type jitter
Required
By default, the test type is
ICMP.
Configure the destination
IP address
destination-ip ip-address
Required
The destination address
must be the IP address of
a UDP listening service on
the HWPing server.
By default, no destination
address is configured.
Configure the destination
port
destination-port
Port-number
Required
The destination port must
be the port of a UDP
listening service on the
HWPing server.
By default, no destination
port is configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP
address is configured.
To Next Page
Loading...
