Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-15
Operation Command Description
Display test results
display hwping results
[ admin-name
operation-tag ]
Required
You can execute the
command in any view.
7) Configuring TCP test on HWPing client
Table 1-11 Configure TCP test on HWPing client
Operation Command Description
Enter system view
system-view
—
Enable the HWPing client
function
hwping-agent enable
Required
By default, the HWPing
client function is disabled.
Create a HWPing test
group and enter its view
hwping
administrator-name
operation- tag
Required
By default, no test group
is configured.
Configure the test type
test-type { tcpprivate |
tcppublic }
Required
By default, the test type is
ICMP.
Configure the destination
address
destination-ip ip-address
Required
This IP address and the
one configured on the
HWPing server for
listening services must be
the same.
By default, no destination
address is configured.
Configure the destination
port
destination-port
port-number
Required in a Tcpprivate
test
A Tcppublic test is a TCP
connection test on port 7.
Use the hwping-server
tcpconnect ip-address 7
command on the server to
configure the listening
service port; otherwise the
test will fail. No port
number needs to be
configured on the client;
any destination port
number configured on the
client will not take effect.
By default, no destination
port number is configured.
To Next Page
Loading...
