Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-32
# Configure the destination IP address as 10.2.2.2.
[Sysname-hwping-administrator-snmp] destination-ip 10.2.2.2
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-snmp] count 10
# Set the probe timeout time to 30 seconds.
[Sysname-hwping-administrator-snmp] timeout 30
# Start the test.
[Sysname-hwping-administrator-snmp] test-enable
# Display test results
[Sysname-hwping-administrator-snmp] display hwping results administrator
snmp
HWPing entry(admin administrator, tag snmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 9/11/10
Square-Sum of Round Trip Time: 983
Last complete test time: 2000-4-3 8:57:20.0
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[Sysname-hwping-administrator-snmp] display hwping history administrator
snmp
HWPing entry(admin administrator, tag snmp) history record:
Index Response Status LastRC Time
1 10 1 0 2000-04-03 08:57:20.0
2 10 1 0 2000-04-03 08:57:20.0
3 10 1 0 2000-04-03 08:57:20.0
4 10 1 0 2000-04-03 08:57:19.9
5 9 1 0 2000-04-03 08:57:19.9
6 11 1 0 2000-04-03 08:57:19.9
7 10 1 0 2000-04-03 08:57:19.9
8 10 1 0 2000-04-03 08:57:19.9
9 10 1 0 2000-04-03 08:57:19.8
10 10 1 0 2000-04-03 08:57:19.8
For detailed output description, see the corresponding command manual.
To Next Page
Loading...
