H3C S3100 8C SI - Page 932

Operation Manual – Smart Link-Monitor Link
H3C S3100 Series Ethernet Switches Chapter 1 Smart Link Configuration
1-9
# Configure to send flush messages within VLAN 1.
[SwitchA-smlk-group1] flush enable control-vlan 1
2) Enable the function of processing flush messages received from VLAN 1 on
Switch C.
# Enter system view.
<SwitchC> system-view
# Enable the function of processing flush messages received from VLAN 1 on Ethernet
1/0/2.
<SwitchC> smart-link flush enable control-vlan 1 port Ethernet 1/0/2
3) Enable the function of processing flush messages received from VLAN 1 on
Switch D.
# Enter system view.
<SwitchD> system-view
# Enable the function of processing flush messages received from VLAN 1 on Ethernet
1/0/2.
[SwitchD] smart-link flush enable control-vlan 1 port Ethernet 1/0/2
4) Enable the function of processing flush messages received from VLAN 1 on
Switch E.
# Enter system view.
<SwitchE> system-view
# Enable the function of processing flush messages received from VLAN 1 on Ethernet
1/0/2 and Ethernet 1/0/3.
[SwitchE] smart-link flush enable control-vlan 1 port Ethernet 1/0/2 to
Ethernet 1/0/3