Harmonic ELECTRA VS - Page 16

Preface — About this Manual
16 Electra VS - Version 05.01
User Manual - Rev. A
About this Manual
This manual is written for Operators of the Electra VS.
The manual is organized into the following chapters and appendices:
 Chapter 1 ’Overview’ gives a general description of the equipment
and its main features. It also identifies the controls, indicators and
connectors on the front and rear panels.
 Chapter 2 ’Installation and Startup’ provides the procedures
required for Electra VS installation and initial configuration. It also
contains a list of HP documents to which you can refer for more
information on the blade centers (Hardware delivery).
 Chapter 3 ’Web User Graphical Interface’ details how to use the Web
Browser Graphical User Interface.
 Chapter 4 ’Servicing’ describes how to add or replace nodes of your
system (Hardware delivery), and how to add licenses.
 Chapter 5 ’Troubleshooting’ describes the procedure to follow when
you face any problem with the equipment.
 Chapter 6 ’Customer Service’ provides you with the customer
service contacts and information on how to return a product.
 Chapter 7 ’Tools’ describes the Equipment Setup tool delivered on
the DVD-ROM with the product. It describes also the NodeBench tool.
 Appendix A ’Technical Specifications’ gives specifications of the
device, device compliance, declarations of conformity and ordering
guide to order the Electra VS and its options.
 Appendix B ’SNMP Management’ explains how to set the SNMP
community string and the access rights. You will also find MIB
description, how to register the SNMP Manager on the Electra VS
Graphical User Interface etc. It also describes the MIB used to
configure and monitor the equipment.
 Appendix C ’Safety Instructions’ gives instructions related to risk of
fire, electric shock or injury to persons. This important section is
available in English, German and French versions.
 Appendix D ’Regulatory Notices’ provides device compliances.
 Appendix E ’Logs’ gives the list of alarms visible in the Logs panel of
the GUI (XML file).
 Appendix F ’Network Settings’ provides detailed information on the
network configuration.
This manual should be kept in a safe place for reference for the life
time of the equipment. If passing the equipment to a third party,
please ensure to pass all relevant documentation including this
manual.