Chapter 2 ’Installation and Startup’ — Hardware Delivery
Electra VS
-
Version 05.10 41
User Manual - Rev. A
Power Supply and Protective Ground
Power Supply Cord(s)
Specifications
The AC mains power cords are only shipped with the device if ordered.
For DC supply units, use power cords suitable with the HP specifications.
Connecting AC Mains Power Supply Cord(s)
Power Supply End
The connection panel should comply with the legislation in force in the
country of installation. The connection panel must be positioned in the
rack in such a way that the plug and power cord(s) are within easy reach
for switching off purposes.
For (each) mains inlet, the wiring system must feature overload and earth
fault protection and a bipolar cut-off device or a differential circuit
breaker. If in doubt, contact a qualified electrician.
Electra VS
End
Plug the power cord(s) into the mains inlet.
Never supply a power supply unit which is not in the chassis.
The built-in overload protection cannot be accessed or reset.
To Next Page
Loading...