Harmonic ELECTRA VS - Blade Center - Upgrading Onboard Administrator Firmware; Connecting to the ILO Interface

Chapter 4 ’Servicing’ — Hardware Delivery
436 Electra VS - Version 05.10
User Manual - Rev. A
Blade Center - Upgrading OnBoard Administrator
firmware
To upgrade the version of your OnBoard Administrator software, follow
the procedure below.
Connecting to the ILO Interface
1. Run Internet Explorer.
2. Enter the IP address of the blade center ILO interface. For more
information, see section
’Connecting to the HP Monitoring Tools’ on
page 473.
3. Enter the user name and password indicated on the asset tag.
The
HP OnBoard Administrator interface is displayed.
4. To upgrade the OA firmware, select Enclosure Settings , Active
OnBoard Administrator
, Upgrade setting view .
Figure 4-42. HP configuration interface – Firmware Update page
5. Check the current firmware version in the Firmware information
table.
6. Select the new firmware and click upload .
Before performing any upgrade, read the Compatibilities section
in the
Electra VS -ReleaseNotes-vxx.xx.00-edx document on the
DVD-ROM supplied with the equipment and check that there is no
limitation on the type of firmware version supported with your
version
.