Harmonic ELECTRA VS - Registering SNMP Manager on the GUI

Appendix B ’SNMP Management’ — Registering SNMP Manager on the GUI
Electra VS - Version 05.10 557
User Manual - Rev. A
Registering SNMP Manager on the GUI
To register a Manager to receive the traps , proceed as follows:
1.
Open the GUI as described in section ’Workflows and Jobs Concept’
on page 80.
2. Select the Setup tab.
3. Select the SNMP category.
4. Click the Edit button on the top-right corner to be able to modify the
values.
5. Fill in the SNMP Port, the Read Community and Read/Write
Community
fields.
6. In the table, add the IP addresses and ports of the SNMP Managers so
that they can receive the traps.
By default, two community strings are declared:
 xxxxPublic associated with R/O access level
 xxxxPrivate associated with R/W access level
To know how to use a table, see Paragraph ’Tables’ on page 91.