Chapter 2 ’Installation and Startup’ — Virtualization Delivery
76 Electra VS
-
Version 05.10
User Manual - Rev. A
setSystemIP
: declare the node as master node. It may be used to
configure the interface of the platform to be in the System Private LAN
(by default eth0).
setIP -a @IP/mask -g @IPgateway -l lannumber <-t if tagged>
-d interface/bond
: configure the Master Node virtual IP address,
after configuration you can access the Web interface using the
address configured.
Example:
setIP -a 198.18.76.244/21 -g 198.18.64.1 -l 3064
-d eth1
The management address will be set to 198.18.76.244 in LAN 3064.
ifConfig
: display the configuration of the interfaces present in the
node. Eth0 is preconfigured and eth1 is in our example configured to
support the management network.
Accessing the Web interface for the First Time
Refer to section
’Accessing the Web Interface for the First Time’
on
page 63.
Adding the Second Node in Electra VS (Masterisable Node)
Add the second node as the first node. Follow all the steps in the section
’Installing the First Node (Master Node)’
on page 69 and section
’Installing the OVA on the first Node (Master Node)’
on page 72.
Do not execute the steps describe in the section
’Configuring the
Interface of the First Node (Master Node)’
on page 75.
Asking a License for Electra VS
Refer to section
’Asking a License for Electra VS’
on page 67.
Declaring a License for Electra VS
Refer to section
’Declaring a License for Electra VS’
on page 67.
Adding Non Masterisable Node(s) to Electra VS
Refer to the
Chapter 4 ’Servicing’
, section
’Adding a Slave Node to
Electra VS’
on page 445.
Defining Processing Capacity of the Nodes
Refer to section
’Defining Processing Capacity of the Nodes’
on
page 68.
To Next Page
Loading...