Chapter 3 ’Web User Graphical Interface’ — Workflow Library
324 Electra VS
-
Version 05.10
User Manual - Rev. A
Outputs
TS Video Packetizer
Description
The
TS Video Packetizer
processing component encapsulates a video
elementary stream into MPEG-2 transport packets. These packets can
then be sent to a TS multiplexer.
Figure 3-292. TS video packetizer parameters
Parameters
For this processing component, you must set the following parameters:
PCR generation
: select the PCR generation mode:
Add on component
: add PCR on the video component.
Create independent PCR PID
: an independent PID for the PCR is
created. Choose this mode for ISDB-Tb programs. In this case,
you must indicate the PID value in the
TS multiplexer
processing component, in the
Input
tab, in the
PCR PID
field.
See section
’TS Multiplexer’
on page 327.
None
: no PCR is added.
Encoder Boundary Point
: Select the standard to apply (
CableLabs
)
if you want to add adaptive streaming specific signaling information.
The generated stream will be pre-conditioned integrating fragments
and segment boundaries information (an EBP is added before each Idr
frame of the WebTV video stream). Otherwise, select
None
.
Adaptation for Anevia’s external packager
: set to
true
to
generate a transport stream that can be read and processed by
Anevia’s ViaMotion devices. Do not use this feature if your TS is not
sent to external packager. The following adaptation is performed:
Add of the ES_rate field in all audio and video PES headers.
To Next Page
Loading...