Harmonic ELECTRA VS - Rtmp

Chapter 3 ’Web User Graphical Interface’ — Workflow Library
338 Electra VS - Version 05.10
User Manual - Rev. A
RTMP
Description
The RTMP processing component sends audio/video to a Flash Media
Server (FMS) using RTMP push (to TCP port 1935 of the FMS server).
Adaptive bitrate is supported (a single chunker shall be defined for all the
video components).
Figure 3-306. RTMP output parameters
Parameters
For this processing component, you must set the following parameters.
Parameters Tab
 Flash media server URL : indicate the URL used to communicate
with the Flash media Server (FMS). The syntax shall be the following
rtmp://host_name[:port]/path or rtmp://host_ip[:port]/path 
If the port is not indicated, the default RTMP port 1935 is used.
If the syntax is
rtmp://host_name[:port]/path
 you shall configure the DNS in the Setup tab, IP category (see
Chapter
Installation )
 you shall indicate the LAN used to communicate with the
remote RTMP server
If the syntax is
rtmp://host_ip[:port]/path
 you do not have to configure the DNS
 you shall set the address directly in the Flash media server IP
address
 Delay before reconnection: indicate the maximum delay
between each tentative of reconnection to the Flash media server
(default 1 s).
 Authentication type : choose:
 None or in FMS URL : if there is no authentication or it is
indicated in the URL of the flash media server.
 Akamai : if the authentication is managed by an Akamai server.
In this case, indicate the
User name and Password to use.