Chapter 4 ’Servicing’ — Software Only Delivery
Electra VS
-
Version 05.10 439
User Manual - Rev. A
Software Only Delivery
Managing the Recovery Points
Refer to section
’Managing the Recovery Points’
on page 408.
Upgrading the Software Release
Refer to section
’Upgrading the Software Release’
on page 410.
Requesting a New License File
Refer to section
’Requesting a new license File’
on page 411.
Declaring a New License File
Refer to section
’Declaring a new License File’
on page 412.
Creating a Bootable USB Flash Drive
Refer to
Chapter 2 ’Installation and Startup’
, section
’Creating the
Bootable USB Flash drive’
on page 58.
Installing the Version on the First Node (Master node)
Refer to
Chapter 2 ’Installation and Startup’
, section
’Installing the
Version on the First Node (Master Node)’
on page 58.
Adding Masterisable Node to Electra VS
Refer to
Chapter 2 ’Installation and Startup’
, section
’Adding the
Second Masterisable Node in Electra VS’
on page 65.
Adding Non Masterisable Node(s) to Electra VS
If you want to expand the Electra VS by adding an additional server, you
first need to purchase the physical slave nodes.
1.
Plug them in the same way as the other nodes.
You then need to declare them in Electra VS.
To Next Page
Loading...