Chapter 3 ’Web User Graphical Interface’ — Workflow Library
Electra VS
-
Version 05.10 337
User Manual - Rev. A
TS File Output
The
TS file
output processing component allows you to record the
output of a TS multiplexer into a file.
Figure 3-305. TS file output parameters
For this processing component, you must set the following parameters:
TS file storage
: indicate the network storage where the output TS
file must be placed. Refer to section
’Video overlay’
on page 296 for
the possibles syntaxes.
TS file folder
: indicate the folder on the network storage where the
output TS file must be placed.
TS file name
: specify the name of the output TS file.
TS file name extension
: specify the file extension that the output
TS file should have.
If this parameter is not filled, the TS file name will be kept "as is".
If this parameter is filled, any extension of the TS file name parameter
will be replaced by this extension. This is useful when you want to
keep the input file name (hot folder application, for example) and
replace only the extension: you link the TS file name to the input TS
file name, and you force the extension using the
TS file name
extension
.
To Next Page
Loading...