Harmonic ELECTRA VS - TS over IP Streamer

Chapter 3 ’Web User Graphical Interface’ — Workflow Library
332 Electra VS - Version 05.10
User Manual - Rev. A
TS over IP Streamer
Description
The TS over IP Streamer output processing component streams an
MPEG-2 TS over UDP/IP or over RTP/UDP/IP in CBR mode (i.e. with
stuffing packets) or in VBR mode (i.e. without stuffing packets). Both
multicast and unicast are supported.
Figure 3-301. TS over IP streamer output parameters
Parameters
For this processing component, you must set the following parameters:
 IP address : to set the IP destination address.
 If the address is multicast, set the LAN and enter the IP address
in the field.
 If the address unicast, it must be reachable, otherwise job
creation will be refused. To check that the address is reachable,
Electra VS uses its IP configuration (LAN, default gateways, IP
routes).
Figure 3-302. IP address
 UDP port : destination UDP port.
 Source IP address : to set the source IP address. 
Leave to Auto to fill it with the IP address in the output LAN of the node
on which the job is running. If the job is stopped and is restarted on a
different node, the source IP address will change.

Declare a Source IP address if you want to always use the same one
whatever the node on which the job is running.