Harmonic ELECTRA VS - Setup;Monitoring

Chapter 3 ’Web User Graphical Interface’ — GUI Description
176 Electra VS - Version 05.10
User Manual - Rev. A
Setup/Monitoring
Figure 3-134. Monitoring configuration
The SNMP category lets you perform the SNMP configuration.
 Read community : enter the name of the community.
 Read/Write community : enter the name of the community.
 SNMP port
The table gives you the list of trap destination IP addresses with their
associated SNMP version.
For more information on SNMP, refer to
Appendix B ’SNMP
Management’
on page 551.
The
LAN protocol access category lets you indicate the protocols
accessible from external only and management LANs. You can allow or
block HTTP, HTTPs, SSH and SNMP connections.
It is recommended to allow protocol access only from management LAN
in order to avoid security breaches.