Chapter 5 ’Troubleshooting’ — Troubleshooting Procedures
Electra VS
-
Version 05.10 451
User Manual - Rev. A
Modifying a Workflow from a Text Editor
If needed, you may perform some changes in the code, and then import
them back in the GUI to apply your changes. To do so:
1.
Follow the steps described above to export the workflows
configuration to a zip file.
2.
Find the XML file corresponding to the workflow you wish to modify
and extract it from the zip.
3.
Open the XML file in a text editor.
4.
Perform your changes.
5.
Re-include the XML file of the workflow in the original ZIP file.
6.
In the lower-right corner of the GUI, click
Import
and select the ZIP
file.
The modified workflow is now available in the list of workflows.
Exporting Logs
To export logs, proceed as follows:
1.
From the GUI, open the
Setup
tab.
2.
Select the
Logs
category.
3.
From the
Export
area, click the
Export now
button to export the
logs immediately.
A text file is generated with all the logs stored in the database.
For more information on the export feature, refer to section
’Export’
on
page 181.
Using the Console
The
Console
tab is available only if you are logged with an
administrator account. To display / hide the
Console
tab press
CTRL
+
D
keys. The
Console
tab is described in section
’Console Tab’
on
page 227.
This tab should be used only under the customer support’s supervision.
If needed, the customer support team will indicate the commands to
send.
To Next Page
Loading...