Harmonic ELECTRA VS - Security Specifications

Appendix A ’Technical Specifications’ — Common Specifications
Electra VS - Version 05.10 539
User Manual - Rev. A
Security Specifications
The following Control-Command specifications are supported:
 Web GUI (https)
 Web Services (http/SOAP)
 SNMP v1, v2c
 IP v4
 NTP v4 for NTP server connection
 PTP v2
For remote connections, only SSHv2 is supported.
For authentication, LDAP and LDAPS are supported.
In the following table, note the open TCP/UDP ports according to the LAN
protocol access configuration. The xxxx ports are dynamic ports. The
port values may vary between 512 and 1023, and may change on each
platform.
Table A-69. Security specifications
Port Service Master node Slave node
22/tcp
SSH Remote Login Protocol If Allow SSH checked If Allow SSH checked
68/udp BOOTP client (Equipment Setup
connection)
Open Open
80/tcp World wide Web HTTP Apache port
80
If Allow HTTP checked If Allow HTTP checked
111 /t c p SUN Remote Procedure Call Open Open
111 /u dp SUN Remote Procedure Call Open Open
123/udp Network Time Protocol Open
161/udp net-SNMP If Allow SNMP checked
201/tcp rpc status Open Open
201/udp rpc status Open Open
443/tcp HTTP protocol over TLS/SSL If Allow HTTPS checked If Allow HTTPS checked
xxxxx/udp Rpcbinf Open Open