Chapter 4 ’Servicing’ — Virtualization Delivery
Electra VS
-
Version 05.10 445
User Manual - Rev. A
Adding a Slave Node to Electra VS
If you want to expand your Electra VS by adding an additional server, you
first need to download the virtual machine on the node using the ESXI
Follow steps section
’Installing the First Node (Master Node)’
on
page 69 to section
’Installing the OVA on the first Node (Master Node)’
on page 72 describe in the
Chapter 2 ’Installation and Startup’
.
You then need to declare it.
1.
Check that your license allow the addition of a new node
a.
In the GUI, point to the Download tab.
b.
In the license table check that you have the right to add new
nodes.
The quantity used of ELC-VS-SW-VOSFLEX shall be lower than
the quantity maximum allowed.
c.
If it is not the case Ask additional license to Harmonic. Refer to
section
’Requesting a new license File’
on page 411 and section
’Declaring a new License File’
on page 412.
2.
Add the node
a.
Go to the Nodes category.
b.
Select Add Nodes.
The new node shall be detected and proposed to be added in
Electra VS.
If it is not the case check the network mapping
c.
Click Next.
3.
The node shall be automatically added in your Electra VS.
4.
Configure the processing capacity of your node. Refer to
Chapter 7
’Tools’
, section
’NodeBench’
on page 466,
5.
Check the status of the node
a.
Select the Hardware tab.
b.
Go to the Nodes category.
c.
Check that the status of the node is OK.
6.
Finalize the network configuration of your node.
To Next Page
Loading...