Harmonic ELECTRA VS - Page 322

Chapter 3 ’Web User Graphical Interface’ — Workflow Library
322 Electra VS - Version 05.10
User Manual - Rev. A
 Bandwidth lowpass filter : this parameter can be used to
activate a low-pass filter with a cut-off near the specified audio
bandwidth that is applied to the main input channels. If the
digital signal fed to the main input channels does not contain
information above the specified audio bandwidth, this filter can
be disabled.
 Mixing level : acoustic pressure of the sound during the final
mixing, in decibels.
 Bitrate for Mono : choose from the list the bitrate to use for mono
audio.
 Bitrate for Stereo : choose from the list the bitrate to use for stereo
audio.
 Bitrate for 5.1 : choose from the list the bitrate to use for 5.1 audio.
 Bitstream mode : choose from the list the type of audio service:
 Complete main : main audio service
 Music and effect : main audio service
 Visually impaired : associated service
 Hearing impaired : associated service
 Dialogue : associated service
 Commentary : associated service
 Emergency : associated service
 Voiceover : associated service
 Karaoke : associated service
 Line mode DRC : information used by Dolby® Digital audio
decoders with line-level outputs, to adjust their output dynamic
according to a profile. Choose from the list the line mode to use for
Dynamic Range Control.
 RF mode DRC : information used by Dolby® Digital audio decoders
with an RF-remodulated output, to adjust their output dynamic
according to a profile. Choose the profile from the list.
 Preferred stereo downmix mode (multi-channel only) :
choose from the list if you would rather use Lt/Rt or Lo/Ro downmix in
a decoder with stereo outputs:
 Lt/Rt preferred : Left total/Right total. The Lt/Rt downmix totals
the Surround channels and adds them in-phase to the Left
channel and out-of-phase to the Right channel. This enables a
Dolby Pro Logic decoder to rebuild the L/C/R/S channels for a Pro
Logic home theater.