Chapter 3 ’Web User Graphical Interface’ — Workflow Library
328 Electra VS
-
Version 05.10
User Manual - Rev. A
PMT period
: enter the period of all the PMT, in milliseconds.
Same note as before.
Standard
: set the standard that the output TS should respect (DVB,
MPEG-2 or ATSC). This information is required for some processing
(e.g. AC-3 transport since the AC-3 transport mode is not the same in
ATSC and DVB).
Generate SDT
: If set to
true
, a SDT will be created and filled using
the TS Id, ON Id, Service type, Service name and Provider name
configured in the multiplexer.
SDT Period
: enter the period of the SDT in milliseconds.
ON Id
: enter the Original Network Id.
In the
Input: Input
tab (one tab per TS input)
Input type
:
If set to
Program,
define a program and a component of this program.
according to the following parameters:
Figure 3-296. Input: Input tab (Input type Program)
Program number
: program number the component belongs
to.
Component PID:
enter a value or use a link to an input
component label.
To Next Page
Loading...