Chapter 3 ’Web User Graphical Interface’ — Workflow Library
344 Electra VS
-
Version 05.10
User Manual - Rev. A
Stream available on local web server
:
if set to
true
, the stream
is available on the Electra VS internal Web server. In this case, set the
following parameters:
Local Web server IP address
: virtual IP address. A player
can receive the chunks from this address. This address must be
part of a Electra VS LAN, otherwise job creation will be refused.
Folder
: folder where the manifests and chunks are stored on
the local Web server.
Max clients number
: expected maximum number of clients
for this output stream. This parameter is used to check that the
device has the resource to process the requests for this stream.
Push stream on remote web server
: if set to
true
, the stream is
pushed to a remote Web server. In this case, set the following
parameters:
Remote web server URL
: indicate the LAN used to
communicate with the remote Web server. If the remote Web
server URL contains a name instead of an IP address, you must
configure the DNS in the
Setup
tab,
IP
category (see section
’DNS’
on page 171).
If you do not wish to use the IP address resolution by DNS, you
can also directly enter the IP address of the remote Web server
in the
Remote web server IP address
field.
Traffic smoothing
: indicate if you want to smooth the traffic
generated by the chunk transmission to the remote web server
and the
Maximum traffic overhead
accepted (
30%
to
500%
).
The overhead is calculated on the theoretical broadcast bitrate.
It means that with an maximum overhead set to 100% the traffic
bitrate will not exceed two times the estimated bitrate.
Delete files from remote web server
: if set to
true
, the files
posted on the remote Web server are deleted after the
Available stream duration
set above.
Create directory on remote web server
: if set to
true
, the
root directory is created before chunks transfer. If
Activate
directory rollover
is set to
true
, sub-directories named
Rollover_X
are automatically created. The sub-directories and
the chunks are deleted after the
Available stream duration
set above.
Remote web server authentication
: if the remote Web
server requires an authentication select its HTTP type,
Basic
or
Digest
, and enter the
User name
and
Password
.
To Next Page
Loading...