Chapter 3 ’Web User Graphical Interface’ — Workflow Library
Electra VS
-
Version 05.10 357
User Manual - Rev. A
-
you shall indicate the LAN used to communicate with the
remote Web server
If the syntax is
http://remote_web_server_ip/path/publishing_point.isml
-
you do not have to configure the DNS
-
you shall set the address directly in the
Remote Web
server IP address
Connection to remote server
: select
One single
connection for all profiles
or
One connection per
profile
depending on the remote web server requirements.
Traffic smoothing
: indicate if you want to smooth the traffic
generated by the chunk transmission to the remote web server
and the
Maximum traffic overhead
accepted (
30%
to
500%
).
The overhead is calculated on the theoretical broadcast bitrate.
It means that with an maximum overhead set to 100% the traffic
bitrate will not exceed two times the estimated bitrate.
Authentication type
: set the server authentication type
(
auto
,
basic
or
digest
) if the remote Web server requires an
authentication, and enter the
User name
and
Password
.
Use local Web server
: if set to
true
, the chunks are available on the
device’s Web server. In this case, set the following parameters:
Local Web server IP address
: virtual IP address. A player
can receive the chunks from this address. This address must be
part of a Electra VS LAN, otherwise job creation will be refused.
Folder
: folder where the manifests and chunks are stored on
the local Web server.
Max clients number
: expected maximum number of clients
for this output stream. This parameter is used to check that the
device has the resource to process the requests for this stream.
Available stream duration
: depth of chunks that are available on
the Web server. The minimum duration must be equal to the length of
at least two chunks.
Encrypt files
: if set to
true
, DRM is activated. Set the following
parameters:
Algorithm
: two algorithms are available:
-
AES CBC
-
AES CTR
Key server connection
: select the conditional access server
to which Electra VS should connect to get the key from the
drop-down list.
If set to
None
, Electra VS generates the key itself. You must set
To Next Page
Loading...