Chapter 3 ’Web User Graphical Interface’ — Workflow Library
Electra VS
-
Version 05.10 373
User Manual - Rev. A
Figure 3-324. DASH output – ES subtitle parameters
In this tab, you must set the following parameters:
ES Subtitle input ID
: indicate the page number you wish to use. If
left to
Auto
, the first page number of the subtitle is used. This mode is
not suitable when there are several Subtitle IDs in the same input.
ES Subtitle language
: if left to
Auto
, which is fine if the stream
complies with the standard, the Electra VS uses the language
associated with the teletext indicated by the ID. Otherwise, specify the
language manually using the ISO codes
1
(e.g., enter eng for English,
spa for Spanish, etc.).
ES Subtitle representation ID
: media identifier. Enter an
identifier. It must be unique for the component (i.e. it is guaranteed to
be unique among all identifiers). If left to
Auto
a numeric identifier will
be automatically set.
1.
For the whole list of ISO codes, refer to: http://www-01.sil.org/iso639-3/codes.asp?or-
der=639_3&letter=%25
To Next Page
Loading...