Harmonic ELECTRA VS - Page 434

Chapter 4 ’Servicing’ — Hardware Delivery
434 Electra VS - Version 05.10
User Manual - Rev. A
Figure 4-38. Remove node
4. Remove physically the node
 For a 1RU server: switch off the front panel and power the device
off.
 For a blade server: remove the blade (no specific precautions to
take).
5. Insert the new node at the old one’s location
 For a 1RU server: cable the device and start it using the front
panel.
 For a blade server: insert the new blade and start it using the
front panel.
6. Add the new node to Electra VS
 Click Add nodes .
Figure 4-39. Add nodes
 The new node is displayed.
 Check Add , enter the node id and click Next .