Chapter 2 ’Installation and Startup’ — Software Only Delivery
66 Electra VS
-
Version 05.10
User Manual - Rev. A
2.
Connect the first physical interface of the node (eth0) to the GiGE
switch.
3.
From the Web Interface connected to the first node:
a.
Select the
Hardware
tab.
b.
Go to the
Nodes
category.
c.
Select
Add Nodes.
The second node should be detected and displayed in the list.
If it is not the case check the interface configuration and the
switch connection.
d.
Select it and click
Next.
A Network interface profile compatible with the hardware is
automatically associated with the node. Check if the number of
physical interfaces detected is correct.
To Next Page
Loading...