© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
Have a look at this table:
Cue
number
Fixture 1
Dim
Fixture 1
Position
1 100 Singer
2 0 Singer
3 0 Singer
4 0 Singer
5 0 Singer
6 100 Singer
We have stored fixture 1 at 100% and on the Singer position in cue number 1. In cue 2 it’s turned off.
Down in cue 6 it’s turned back on and it’s still used in the singer position - but it’s a tracked value (it's not actually
stored in cue 2 through 6).
Now we would like to use the same fixture in cue 3 at the drummer position.
So we turn it to 100% and selects the Drummer position. This is stored in cue 3.
So this is our current scenario:
Cue
number
Fixture 1
Dim
Fixture 1
Position
1 100 Singer
2 0 Singer
3 100 Drummer
4 100 Drummer
5 100 Drummer
6 100 Singer
So the new drummer position is stored in cue 3 and tracked until cue 6 where the console new that we needed the
Singer position.
Also notice that it has not protected the dimmer value in cue 6 - it's now a tracked value from cue 3.
So now we need to store the dimmer at 0% in cue 4 and cue 5. If we just do this with a normal store, then it'll track
into cue 6 and turn off the dimmer.
Take the dimmer to 0% and store (merge) cue 4 and 5 as Cue Only.
To Next Page
Loading...
