© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
To leave the Status and Messages window, tap in the title bar or press Esc on the console.
Status and Messages in Detail
Session Status Master:
The dot2 is the master of a session.
The blue heart is visible after a session is started in the Network Setup.
Session Status Standalone:
The broken red heart is visible if the dot2 is in a standalone mode.
Smiley:
Right beside the command line is the smiley.
The smiley indicates a standalone mode and everything is OK.
Console in a Session:
The dot2 has joined a session.
Network loss:
Network cable or connection is missing or defect. Double-check the network connection.
DMX Tester Output:
DMX tester output is active. To turn the DMX tester off, open the tools window.
Timecode Record:
Timecode record is running for a cue list. To turn the timecode record off, open the respective cues view and tap
TC Record in the title bar.
To Next Page
Loading...
