Controller Options
SM 2-105 D086/D087
Installation
Move Exec
The menu "Move Exec" (SP5-873-001) lets you move application programs from the original
SD card to another SD card.
 Do not turn ON the write protect switch of the system SD card or application SD card
on the machine. If the write protect switch is ON, a download error (e.g. Error Code
44) occurs during a firmware upgrade or application merge.
1. Turn the main switch off.
2. Make sure that a target SD card is in SD Card Slot 1. The application program is moved
to this SD card.
3. Insert the source SD card with the application program in SD Card Slot 2.The application
program is copied from this source SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-001 "Move Exec".
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the source SD card from SD Card Slot 2.
10. Turn the main switch on.
11. Check that the application programs run normally.
Undo Exec
"Undo Exec" (SP5-873-002) lets you move back application programs from an SD card in SD
Card Slot 1 to the original SD card in SD Card Slot 2. You can use this program when, for
example, you have mistakenly copied some programs by using Move Exec (SP5-873-001).
 Do not turn ON the write protect switch of the system SD card or application SD card
on the machine. If the write protect switch is ON, a download error (e.g. Error Code
44) occurs during a firmware upgrade or application merge.
1. Turn the main switch off.
2. Insert the original SD card in SD Card Slot 2. The application program is copied back into
this card.
3. Insert the SD card with the application program in SD Card Slot 1.The application
program is copied back from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-002 "Undo Exec."
To Next Page
Loading...
Need help?
General
