Paper Transfer
SM 4-77 D086/D087
Replacement
and
Adjustment
After installing a new ID sensor unit/board
Do the following adjustment after installing a new ID sensor unit/board.
1. Plug in and turn on the main power switch of the copier.
2. Enter the SP mode.
3. Input two correction coefficients [A] for the ID sensor with SP3-362-013 and
SP3-362-016 on the barcode sheet provided with the new ID sensor unit/board.
For example, input "1.03" with SP3-362-013.
SP numbers other than SP3-362-013 and -016 are not required for this
procedure.
4. Exit the SP mode.
4.9.4 TEMPERATURE AND HUMIDITY SENSOR
1. Rear cover ( p.4-19)
2. Right rear cover (
p.4-19)
3. Temperature and humidity sensor [A] (
x 1, x 1)
To Next Page
Loading...
