Copier Installation
D086/D087 2-10 SM
2.3.3 INSTALLATION PROCEDURE
Remove the tape from the development units before you turn the main switch on.
The development units can be severely damaged if you do not remove the tape.
Put the machine on the paper tray unit or the LCT first if you install an optional paper tray unit
or the optional LCT at the same time. Then install the machine and other options.
Keep the shipping retainers after you install the machine. You may need them in the
future if you transport the machine to another location.
Tapes and Retainers
1. Remove all the tapes and retainers on the machine.
2. Remove all the tapes and retainers in trays 1 and 2, and then take out the power cord
from tray 1 (if applicable).
3. Remove the scanner unit stay [A].
4. Open the front door [B], and then remove the jam location sheet [C].
5. Keep the scanner unit stay [A] inside the front door [B].
6. Reattach the jam location sheet.
7. Close the front door.
To Next Page
Loading...
