Error Codes
D393 24 SM
Code Meaning Suggested Cause/Action
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters in Service Program
Mode
0-05
Modem training fails even
G3 shifts down to 2400
bps.
Check the line connection.
Try adjusting the tx level and/or cable
equalizer.
Replace the FCU.
Check for line problems.
Cross reference
See error code 0-04.
0-06
The other terminal did not
reply to DCS
Check the line connection.
Try adjusting the tx level and/or cable
equalizer settings.
Replace the FCU.
The other end may be defective or
incompatible; try sending to another machine.
Check for line problems.
Cross reference
See error code 0-04.
0-07
No post-message
response from the other
end after a page was sent
Check the line connection.
Replace the FCU.
The other end may have jammed or run out of
paper.
The other end user may have disconnected
the call.
Check for a bad line.
The other end may be defective; try sending to
another machine.
0-08
The other end sent RTN or
PIN after receiving a page,
because there were too
many errors
Check the line connection.
Replace the FCU.
The other end may have jammed, or run out of
paper or memory space.
To Next Page
Loading...
