LCIT PB3110 (D538)
D086/D087 2-38 SM
4. Remove trays 1 and 2 of the machine.
5. Fasten the spring washer screw [D].
6. Reinstall all trays.
7. Attach the securing brackets [E] (
x 1 each; M4x10).
One of the securing brackets is used as a securing tool (the cutout [F] is used in
step 5). But the cutout [G] is for attaching the tray heater. Therefore, attach the
securing brackets [E] after installing the tray heater if you install the tray heater.
8. Load paper into the LCT.
9. Turn on the main power switch of the machine.
10. Check the LCT operation and copy quality.
To Next Page
Loading...
