Safran CORTEX Series - Transport Layer Status; Test Modulation Unit; Selecting the DNRZ Code in QPSK and OQPSK Modulation Mode; Global HDR

HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Page 209
Transport layer status 4.2.9.3.18
Registry path: HKEY_LOCAL_MACHINE/SOFTWARE/InSnec/CrtxHdr/SetDefault/Signal
Processing/Dpu#n
Keyword: PermanentTransportStatus
0: when the frame synchronizer of the CADU layer is unlock, the counters of the Transport layer are set
to 0 and not updated
1: when the frame synchronizer of the CADU layer is unlock, the counters of the Transport layer are
updated.
Default setting: 0
Test Modulation Unit 4.2.9.4
Selecting the DNRZ code in QPSK and OQPSK modulation mode: 4.2.9.4.1
Registry path: HKEY_LOCAL_MACHINE/SOFTWARE/In-Snec/CrtxHdr/SetDefault/Signal
Processing /tstu
Keyword: DNRZ_code
Default setting: 0
Global HDR 4.2.9.5
Selecting LVDS / ECL inputs of the test modulator: 4.2.9.5.1
Registry path: HKEY_LOCAL_MACHINE/SOFTWARE/In-Snec/CrtxHdr/SetDefault/Signal
Processing /Global
Keyword: LVDS_input
0: selection of the ECL inputs
1: selection of the LVDS inputs
Default setting: 0
Recording in raw data mode: 4.2.9.5.2
Registry path: HKEY_LOCAL_MACHINE/SOFTWARE/In-Snec/CrtxHdr/SetDefault/Signal
Processing /Global
Keyword: UnlockedNoTM
0: in raw data mode, data are recorded even if the demodulator is not locked
1: in raw data mode, data are recorded only if the bit synchronizer of the demodulator is locked
Default setting: 0