HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Configuration 4.5.9.2.1
Select the source of the data for the replay:
Report TM: Selects recorded data from a previous satellite pass (from the
recorded report file of the pass – refer to “From report” command)
Playback Data from File: Selects data recorded inside a User-defined file
Playback Data from Directory: Selects data recorded inside a set of User-
defined files recorded inside one directory
Rec Frames by date: Selects data CADUs by dates
BER file : Selects a PRN code or a data simulation file
Playback LAN
Selects the length of the data frames for the playback (synchronization word
included).
Enables to indicate that TM blocks of the file(s) to be replayed are 64-BIT aligned.
Enables to indicate that a date field (8-bytes word) is inserted in the TM block of the
file(s) to be replayed.
Enables to indicate that a status field (8-bytes word) is inserted in the TM block of
the file(s) to be replayed.
Enables to indicate if other spare 8-bytes words are inserted in the TM block of the
file(s) to be replayed. Number of words from 0 to 8.
Enable or disable the loop replay on the selected file.
A to H selection of the DRU from where the replayed data are extracted.
Date of the first CADU to replay (only in “Rec Frames by date” mode)
Date of the last CADU to replay (only in “Rec Frames by date” mode)
Identification of the Playback data flow. This value is reported in all TCP-IP
messages transmitted over the Playback ports (PBK-1 or PBK-2). Enter any
hexadecimal value from 0 to FFFFFFFF (only in “Playback LAN” mode)
Stop session if overrun is detected (only in “Playback LAN” mode)
To Next Page
Loading...
