Safran CORTEX Series - PCM Simulation; Doppler Simulation; Start-Up Menus

HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Page 55
PCM Simulation 1.6.6.4
Operating mode Fixed pattern:
ASCII-coded file on hard disk (32768 bytes)
Separate or merged I and Q data flows
Programmable pseudo-random pattern: 2
10
, 2
11
, 2
15
, 2
23
,2
31
External Data + CLK (serial mode)
PCM coding NRZ-L/M/S, DNRZ, BP-L/M/S
Convolutional code (Viterbi)
TCM (2/3, 2.25/3, 2.5/3, 2.75/3, 5/6 6D DSNG)
CCSDS Reed-Solomon
DVB Reed-Solomon
LDPC 7/8
PCM modulation ON or OFF
Polarity of transmitted NRZ-L Normal or inverted
BER test capability Yes (by the Demodulator)
BER measurement from recorded data on external Data+Clock
inputs
TM test ports Data and Clock (I & Q)
Level: ECL single ended or differential (hard-wired at delivery)
Data: NRZ-L
Clock phase: 0°
External Data & Clock Level: ECL differential (hard-wired at delivery)
Data: NRZ-L (serial mode)
Clock phase: 180°
Clock jitter: as per input clock jitter
Modulator board termination must be either voltage terminated
(unbalanced) or not (balanced). Factory setting: as per Customer
Doppler Simulation 1.6.6.5
Frequency range 0 to +/- 2MHz
Rate 0 to 100 KHz/s
Start-up Menus 1.6.7
The CORTEX HDR supports multiple start-up menus. See section 4.4.9 for more details on the
functionalities supported by each menu.