Safran CORTEX Series - Monitoring; Upper Banner; Recorder Status

HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Page 314
The recording cannot be started as long as the HDR is not set in “Acquisition” mode; use the
button to switch from “Configuration” mode to the “Acquisition” mode.
Monitoring 4.5.7.2.2
Status & alarms in this window are described in DRU.
Upper Banner 4.5.7.2.2.1
See section 4.5.4.1.2.1 .
Recorder Status
4.5.7.2.2.2
 Session Status:
RECORDED DATA
Amount of recorded data for the current recording session. Expressed in
Mbytes
NBR. OF RECORDED FILES
Recorded TM file number for the current recording session. 0 to N
DATE OF FIRST BLOCK
Time-tag of the first recorded TM Block for the current recording session
DATE OF LAST BLOCK
Time-tag of the last recorded TM Block for the current recording session
 TM Status:
CTRL/PART
Active hard disk controller (0 or 1) / Active hard disk partition (1 to 64)
 Disk Information:
CAPACITY
Total data recording capacity for both hard disk controllers (in Mbytes)
OCCUPIED
Occupied capacity for both hard disk controllers (in Mbytes)
FREE
Free capacity for both hard disk controllers (in Mbytes)
NUMBER OF SESSION
Number of recording sessions on the disk
 TM Information:
FILE SIZE
Size of the TM File (in bytes). This value corresponds to the TM block size
multiplied by the value set in “TM block per”.
FILE HEADER
TM File header
BLOCK SIZE
TM Block size (in bytes). Up to 1,048, 656 bytes. This value corresponds to
the defined frame (CADU) size plus a few bytes of time tagging and frame
sync. Status.